I’m generally against modifications. I have seen too many vintage synths spoiled by badly drilled holes that hold fragile switches, connected through an “umbilical cord” to undocumented perf-board based mods made decades ago, and then more wires soldered to the circuit boards. Working on the gear becomes difficult as these wires are holding the case to the cards, and of course wires fatigue and come away, and you have a challenge as to where they once went, and how the mod is supposed to work.
I do see the benefits of a good MIDI implementation, and I have come across a couple of MIDI kits where the designers have come up with good clean designs that can be unplugged for service. In this entry I talk about the Turbo CPU upgrade kit from MTG (Music Technologies Group). Grant runs the MTG and I have found him responsive, friendly, and helpful so recommend doing business with him.
In a different post I will talk about a nice MIDI solution for the Roland TR-808 from another vendor.
All of the instructions are available to download from MTG (http://www.musictechnologiesgroup.com/index.html), so you can see what is involved. I’m on the list of experienced installers and would be happy to implement this for you, but note that I am not a reseller so you have to purchase the kit from MTG. Turbo CPU a simple removal of the CPU and install of the Turbo CPU module.
I think most folks would be interested in the MIDI interface which for a solid installation does mean drilling the base of case to mount the MIDI interface card, and the back of the case for the MIDI connectors.
I prefer the look of the MIDI connectors squeezed between the lettering, and made some identification labels for the MIDI ports. Both customers for this kit wanted the MIDI interface, plus the “DIY” CV interface which adds a tiny MCP4728 chip to the v2.00 MIDI board (I was fortunate that the MCP4728 was pre-installed on one unit, but had to order it from Mouser for the other.
Fine soldering skills are required to install this chip as it is surface mounted, so ask Grant if you can have a card with the MCP4728 pre-installed when you order :-). The DIY CV interface gives you MIDI control over 4 CV wires and is a great addition that requires no trace cutting or case butchering, so I like it!